4. Select Test Mode and click Display.
Your meter is now in test mode, and the Test Mode screen is displayed.
5. Select the different tabs to view your meter’s test mode values and modify test mode
parameters.
6. Click Close to take your meter out of test mode.
Putting your meter in test mode using the display
You can put your meter into test mode using the display.
NOTE: You cannot place a revenue-locked meter into test mode.
1. Press the Home button.
2. Press Up or Down to navigate to Normal Display Mode.
3. Press Select.
4. Press Down to navigate to Test Mode.
5. Press Select to enter the Test Mode Screens. Enter the meter password if prompted and
press Select.
The Test Mode menu displays briefly before switching to the first Test Mode screen.
6. View the test mode screens by pressing Up or Down.
7. Press the Home button to return to Test Mode Screens. Press Down to highlight Exit Test
Mode, then press Select.
Cleaning instructions
Your meter is rated for Pollution Degree 2: Normally, only non-conductive pollution occurs.
Occasionally, however, a temporary conductivity caused by condensation may be expected.
You should periodically inspect and clean your meter. Non-conductive pollution could negatively
impact the meter by impeding air flow and cooling. Abrasive contaminants can reduce the meter
lifespan.
NOTE: The meter is rated as IP30 (not protected from liquids.) The front of the meter display is
rated as IP54 (dust and water resistant) or IP65 (dust and water proof.) To review your meter's
display specifications, see "Display" on page 297.
Prerequisites:
•
Turn off all power supplying the device before cleaning it.
9810 series - User manual Maintenance
7EN05-0390-08 274
To Next Page
Loading...
