Siemens US2:9810RC - Advanced Security Mode

Area Setting Default
Security mode
Advanced security mode
(advanced.scf)
Enabled if Advanced security was
used before upgrading meter
firmware to v3.0.0. See "Advanced
security mode" on page 48 for
details.
Legacy security support
(standard.scf)
Enabled if Standard security was
used before upgrading meter
firmware to v3.0.0.
We recommend that you use
Advanced security mode.
See:
•
“Legacy security support” for
details on Legacy security
support.
•
"Setting up Advanced security"
on page 41 for information on
switching to Advanced security
mode.
For recommendations on how to configure and use your meter in a protected environment, see
"Recommended actions" on page 23.
Advanced security mode
Advanced security mode lets you add up to 50 users, has strong user login, and privilege
management.
NOTE: We recommend that you use Advanced security mode.
This topic lists the advanced mode security capabilities, as well as detailed information on user
access permissions, and the default username and password.
Advanced security mode capabilities
The following table lists the security capabilities of advanced security mode:
9810 series - User manual Cybersecurity
7EN05-0390-08 48