Siemens US2:9810RC - Page 76

Setting Display ION Setup Webpages
IPv6 enabled W W W
IPv6 Link Local Address R R R
IPv6 global address R W W
IPv6 gateway R W W
Ethernet Rx timeout — W W
Modbus TCP timeout — W W
Modbus gateway — W —
MAC address R R R
Ethernet primary DNS R W W
Ethernet secondary DNS R W W
Configuring IPv4 / IPv6 communications settings using ION Setup
You can configure your device’s IPv4 and IPv6 address settings, such as stored addresses or
address assignment mode, using ION Setup.
When configuring communications parameters, ensure you maintain at least one communication
path that allows full access to your device; otherwise, you may permanently lose the ability to
change your device’s configuration and access additional data.
NOTICE
LOSSOFACCESS
Failure to follow these instructions can result in loss of access to the device.
Ensure you maintain sufficient access to communicate with and configure your device.
Contact your network system administrator for your IP addresses and other Ethernet network
configuration values.
To configure IPv4 / IPv6 communications settings using IONSetup:
1. Start ION Setup.
2. Open the Setup Assistant for your device.
3. Click Communications > Basic Ethernet > IPv4 (or IPv6).
4. Select the IP address then click Edit.
9810 series - User manual Communications
7EN05-0390-08 76