Parameter Value Description
Device name
Contact your local network
administrator for parameter
values.
The Ethernet device name is used by DPWS
for self-discovery over Ethernet and as the
hostname to uniquely identify your meter for
DHCP and DNS.
By default, this is set to the meter model plus
the last six-digits of the MAC address.
Domain name
Contact your local network
administrator for parameter
values.
The Ethernet domain name for the network
that the meter resides on.
DHCP settings available using ION Setup
Parameter Value Description
IP address
Contact your local network
administrator for parameter
values.
The IP address of your device.
Subnet Mask
Contact your local network
administrator for parameter
values.
The subnet IP address of your network.
Gateway
Contact your local network
administrator for parameter
values.
The gateway IP address of your network.
Stored IPv4 settings available using ION Setup
Parameter Value Description
Global Address
Contact your local network
administrator for parameter
values.
The Internet protocol address of your device.
Default Gateway
Contact your local network
administrator for parameter
values.
The address the meter uses to route
communications to a different network or
subnet.
If you do not set this or the address is
incorrect, you may see slow communications
or communications errors.
Stored IPv6 address settings available using ION Setup
ION Setup reconnection
If you change the settings for the Ethernet connection method you are currently using to connect
to the meter, ION Setup tries to reconnect to the meter using the updated information. You can
view the process in the Device reconnection dialog box that appears.
9810 series - User manual Communications
7EN05-0390-08 78
To Next Page
Loading...
