NOTE: To disable communications using IPv4, set the Assignment mode to Stored and the IPv4
Address to 0.0.0.0.
Parameter Value Description
IPv6 Assignment Mode
Stored
DHCPv6
Stored: The meter uses the IP addresses that
you manually enter for IPv6 (Global address,
gateway address).
DHCPv6: The meter acquires its IP addresses
from your network’s DHCP server.
IPv6 Link Local Address Read-only
TheIPv6 Link Local address is factory set and
is read-only.
Stored IPv6 Global
Address
Contact your
local network
administrator for
parameter
values.
The Internet protocol address of your device.
Stored IPv6 Gateway
Contact your
local network
administrator for
parameter
values.
The address the meter uses to route
communications to a different network or
subnet. If you do not set this parameter or the
address is incorrect, it may result in slow
communications or communications errors.
IPv6 settings available using the webpages
The webpage also displays the acquired IPv6 settings if the Assignment mode is set to DHCP.
NOTE: To disable communications over IPv6, set Enable IPv6 in Advanced Settings to No.
NOTE: You must enclose an IPv6 address in square brackets when typing it in a web browser,
for example: “http://[fe80::260:78ff:fe04:5943]”.
Configuring Ethernet communications settings using the display
You can configure basic Ethernet communications settings using the display.
You can use the display to select the IP address assignment mode for IPv4 and IPv6, configure
stored IPv4 addresses, and view other settings. To configure the Ethernet settings that are not
available on the display or are read-only, use the meter’s webpages or ION Setup.
Prerequisites:
•
Obtain your meter’s IP address and other network information from your network
administrator or IT department.
9810 series - User manual Communications
7EN05-0390-08 82
To Next Page
Loading...
