5.1 General instructions Installation
5 - 4
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
5.1.2 Personnel prerequisites
In the following instructions, the manufacturer assumes that the
personnel possess extensive professional knowledge, securely
master the necessary technical activities, and have been trained in
the use of the DTCO 1381 components as appropriate for the area of
application.
Installation The persons who are charged with the installation of the DTCO 1381
components must complete a training program on the installation
of the DTCO 1381 components.
Activation and calibration The persons who are charged with the activation and calibration of
the DTCO 1381 components must:
• have a valid workshop card.
• complete a training program on the installation, calibration, and
activation of the DTCO 1381 components.
• (in Germany) also fulfil the conditions for executing tasks
according to §57b.
5.1.3 Technical prerequisites
The following requirements must be fulfilled in order to carry out
the assigned tasks:
• The equipment and tools required or recommended by the man-
ufacturer must be available.
• The equipment, testing devices, and furnishings must comply
with the respective valid legal requirements for the country in
which they are used.
When installing the DTCO 1381 please obey the valid legal regula-
tions in your country!
To Next Page
Loading...
