5.5 Performing the installation Installation
5 - 20
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
5.5.3 Checking the place of installation and the cable connections
The following points must be checked before installing the
DTCO 1381:
Legal criteria for the place of
installation
• The recording equipment must be attached in the vehicle in a
way that gives the driver access to all necessary functions while
sitting in the driver’s seat.
• Optical warning messages must be clearly recognizable for the
user, be located in the driver’s field of vision, and be clearly
legible in daylight and during night.
• Optical warning messages may be included in the recording
equipment or be installed remotely (such as a combi-
instrument).
• If installed remotely, the warning message must be labeled with
a " " symbol and be shown in the color "amber" or "orange".
• The characters depicted in the display must be easily visible.
Manufacturer’s specifications for
the place of installation
• Installation angle of the DTCO 1381: max. ± 45°
• Installation angle of the display: max. ± 30°
• There must be sufficient clearance for installing and operating
the DTCO 1381.
Power supply • The DTCO 1381 may only be connected to voltages for which it
is designed and which can be seen in the wiring diagram (label).
Connection cables • When laying the connection cables, make sure that they are
undamaged, that other objects or sources of heat cannot cause
damages, and that the lines cannot cause any undesired inter-
ference or disturbances.
• Make sure that the plug contacts of the connecting cables
ensure a reliable contact, e.g. by using Junior-Power-Timer.
Caution! Danger of fire due to short circuit
Damaged cables can cause short circuits, undesired interferences, or
disturbances.
Please replace damaged cables immediately!
To Next Page
Loading...
