Siemens VDO DTCO 1381 - Installing the KITAS 2171

Service only
5.5 Performing the installation Installation
5 - 22
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
5.5.4 Installing the KITAS 2171
For the installation, the following KITAS versions are available:
• Standard version KITAS 2171.0X
This version is screwed onto the transmission output.
• Integrated version KITAS 2171.20/ 2171.XX
This version is screwed into the transmission output and there is
a variety of lengths for the insertion depth.
Fig. 5 - 9: Installing the KITAS 2171 motion sensor
1. Screw in the KITAS 2171 – integrated version (2a) – into the
transmission output (1).
or
Screw the KITAS 2171 – standard version (2b) – onto the trans-
mission output (1).
Attention!
Use only the version of KITAS 2171 that corresponds with the speci-
fications of the transmission.
When using the integrated version of the KITAS 2171, make sure
you have the correct insertion depth!
1
2a
2b
Attention!
Observe the maximum tightening torque (50 Nm).