Siemens VDO DTCO 1381 - Chapter 10 First Calibration

Service only
Table of contents First calibration
10 - 2
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
Table of contents
Chapter 10 First calibration
10.1 General instructions ................................................... 10-3
10.1.1 Terminology definitions .................................... 10-3
10.1.2 Personnel prerequisites ..................................... 10-4
10.1.3 Technical prerequisites ...................................... 10-4
10.1.4 Handling the tachograph cards ......................... 10-5
10.2 Calibration instructions .............................................. 10-6
10.2.1 Legal requirements for when to
perform a calibration ........................................ 10-6
10.2.2 Access to the calibration functions .................... 10-6
10.2.3 Programming the UTC time ............................... 10-7
10.2.4 Parameter measurements ................................. 10-7
10.2.5 Checking the KITAS 2171 and the
KITAS sensor cable ............................................ 10-8
10.2.6 Pairing with the KITAS 2171 .............................. 10-9
10.3 Testing equipment .................................................... 10-10
10.4 Checking the buffer battery ..................................... 10-11
10.5 Performing the first calibration ................................ 10-12
10.5.1 Inserting workshop card ................................. 10-13
Menu navigation after inserting
workshop card ................................................ 10-14
10.5.2 Legally stipulated parameters .......................... 10-17
10.5.3 Device-specific parameters .............................. 10-17
10.5.4 Other parameters ........................................... 10-18
10.5.5 Entering parameters ....................................... 10-18
10.5.6 Removing workshop card ................................ 10-20
Menu navigation after removing
workshop card ................................................ 10-20
10.5.7 Creating and sealing installation plate ............. 10-21