Siemens VDO DTCO 1381 - Entering Parameters; Other Parameters

Service only
10.5 Performing the first calibration First calibration
10 - 18
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
10.5.4 Other parameters
Other parameters can be updated or acknowledged if necessary:
• Installation date
• Date of the next calibration
•etc.
10.5.5 Entering parameters
Legally stipulated parameters The following parameters are legally stipulated and must be
updated or acknowledged:
• Vehicle identification number
• Vehicle registration number
• Country of registration
• Characteristic coefficient (w-value)
• Recording equipment constant (k-value)*
• Effective wheel circumference
•Tire size
• Legally permitted maximum speed
•Odometer reading
•UTC time
• Calibration date*
* The DTCO 1381 sets this data automatically.
Please refer to the test device instructions for information on how to
enter the calibration parameters.
The DTCO 1381 automatically sets the calibration date and the
purpose of the calibration (2, 3) when the workshop card is
removed.
Via the menu functions you can print (printout vehicle "technical
data") or display (display vehicle "technical data") the calibration
date and the purpose for the calibration.