13.2 Displaying the event and fault memory Events and faults
13 - 6
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
13.2 Displaying the event and fault memory
13.2.1 Driver 1 or driver 2 (inserted tachograph card)
Purpose In this menu you can display the saved events and faults of an
inserted tachograph card.
The event and fault memory can be displayed / printed only when
the vehicle is motionless, and in the case of the ADR variant, only
when the ignition is turned on, see chapter 3.1.3 "Printing or display
of data", page 3-4.
The procedure for driver 2 (tachograph card inserted in card slot 2)
is identical to that for driver 1 (tachograph card inserted in card
slot 1) and will not be described separately below.
Step / menu display Explanation / meaning
1 Starting from the standard display ...
– press repetitively the button until the display "call main menu"
appears and
– acknowledge with the button .
or
– Press the button .
2 – Select "display driver 1" with the button or and
– acknowledge with the button .
3 – Select "driver 1 event" with the button or and
– acknowledge with the button .
4 Similar to an event printout, all events and faults saved on the tacho-
graph card will appear.
Note
The 24 characters of a printout line are shown on two lines of the
display!
If you page backward while paging through the information, you will
be able to move backward only about 20 printout lines.
DBMMáNBJOáNFOV
EJTQMBZ
jláESJWFSá
áá
jláESJWFSá
Yjl FWFOU
ááá
Yjo
f
o
o
65$
To Next Page
Loading...
