Siemens VDO DTCO 1381 - 13.3 Printing the event and fault memory

Service only
13.3 Printing the event and fault memory Events and faults
13 - 8
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
13.3 Printing the event and fault memory
13.3.1 Driver 1 or driver 2 (inserted tachograph card)
Purpose In this menu you can print the saved events and faults of an inserted
tachograph card.
The event and fault memory can be displayed / printed only when
the vehicle is motionless, and in the case of the ADR variant, only
when the ignition is turned on, see chapter 3.1.3 "Printing or display
of data", page 3-4.
The procedure for driver 2 (tachograph card inserted in card slot 2)
is identical to that for driver 1 (tachograph card inserted in card
slot 1) and will not be described separately below.
Step / menu display Explanation / meaning
1 Starting from the standard display ...
– press repetitively the button until the display "call main menu"
appears and
– acknowledge with the button .
or
– Press the button .
2 – Select "printout driver 1" with the button or and
– acknowledge with the button .
3 – Select "driver 1 event" with the button or and
– acknowledge with the button .
4 The DTCO 1381 starts the selected printout and displays this for
approximately three seconds.
DBMMáNBJOáNFOV
QSJOUPVU
joáESJWFSá ááá
joáESJWFSá
YjoáFWFOU ááá
QSJOUPVU
TUBSUFE
The additional pictograms shown in the calibration mode will not be
printed.