Events and faults 13.4 Messages and troubleshooting measures
Edition 07/2007 Technical Description DTCO 1381 13 - 17
TD00.1381.00 132 102
{j
{j
XSPOHáDBSEáUZQF
00000005B3 The inserted card is not a tachograph card.
Possible causes
• The card is not a valid tachograph card
• Card is defective
Measures
– Check to make sure the tachograph card is valid.
– Make sure the tachograph card is correctly inserted and insert
properly if needed.
– Check tachograph card.
{jY
{jY
DBSEáMPDLFE
00000005B3 The inserted workshop card is locked.
Possible causes
• The workshop card has been locked after five unsuccessful PIN
entries.
• Workshop card is defective
Measures
– Check the workshop card.
– Insert a valid (not locked) workshop card.
{p WJNQVMTFTá
XPáJHOJUJPO
4000000900 v-impulses when ignition is switched off.
Measures
– Check whether the DTCO 1381 detects "drive" and stop the
vehicle if necessary.
– Check KITAS 2171 sensor cable and replace if necessary.
– Check the voltage supply of the DTCO 1381; correct the fol-
lowing if necessary:
a) Connection plug and cable (pin assignment, poor con-
nection, loose contact).
b) Voltage on terminal 15; within the specified range?
c) Voltage behavior on terminal 15 during starting; within the
specified range?
Remark
This message consists of:
• Warning message on the display of the DTCO 1381
• TCO status output (System Event = SE) on the CAN bus and on
the info interface
• Signal to output D4 (TCO warning output)
DTCO 1381 display
Picto. Error text MC Error code Meaning, cause and measures
To Next Page
Loading...
