Siemens VDO DTCO 1381 - Display after Ignition on; Display in Standby Mode

Service only
3.2 Display variations Operating the DTCO 1381
3 - 6
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
3.2.2 Display in standby mode
3.2.3 Display after ignition on
Menu display Explanation / meaning
Under the following conditions, the DTCO 1381 will switch into standby
mode after about 5 minutes:
• the vehicle’s ignition is off and
• no events or faults are pending.
The currently set activities will appear in addition to the time and mode.
The DTCO 1381 will switch off the display after another three minutes
(configurable between 1 - 10 minutes).
Standby mode will be cancelled when:
• you switch on the ignition,
• you press any key or
• when the DTCO 1381 announces an event or a fault.
➥ Detailed information, see chapter 14.1.1 "Standby (Power Safe
Mode)", page 14-3.
uád
aááááááááááááááa
Menu display Explanation / meaning
Operational notes
If there is no tachograph card in card slot 1, this note will appear for
approximately 20 seconds and then the standard display will appear.
u d LNI
a LN a
uáád
a j DBSE a