Siemens VDO DTCO 1381 - Menu Function Service

Service only
3.3 Menu functions Operating the DTCO 1381
3 - 14
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
3.3.4 Menu function "Service"
If the DTCO 1381 is in the production status or calibration mode, the
additional "Service" menu function is available.
The software of the DTCO 1381 can be updated with the "Service –
SW-Upgrade" menu function.
You can only upgrade the user software of the DTCO 1381 if you
fulfil further requirements.
Step / menu display Explanation / meaning
1 – Select the menu function "Service" with the button or .
The current software version is shown in the first line.
– Acknowledge with the button .
2 – Start the software upgrade with the button.
The DTCO 1381 starts the software upgrade function.
3 The question "data download done?" appears, i.e. the DTCO 1381
can be upgraded.
or
The message "upgrade module not present" appears, i.e. the DTCO
1381 cannot be upgraded.
Cancel the software upgrade
– Cancel the software upgrade with the button .
The message "upgrade aborted" appears.
After approx. one minute or pressing the button the DTCO 1381
returns to the menu "Service".
YYYYYYááááá
4FSWJDF áá
1
486QHSBEF
TUBSUFE 
4FSWJDF
486QHSBEF áá
VQHSBEF NPEVMF
OPU QSFTFOU
EBUB EPXOMPBE
EPOF OP
YYYYYY 
4FSWJDF áá
VQHSBEF BCPSUFE
Detailed information on the "Software-Upgrade" is contained in the
Technical Description "Software-Upgrade DTCO 1381".