Siemens VDO DTCO 1381 - Menu Navigation after Removing Workshop Card; Removing Workshop Card

Service only
3.4 Calibration mode Operating the DTCO 1381
3 - 20
© Siemens VDO Automotive AG Edition 07/2007
TD00.1381.00 132 102
3.4.2 Removing workshop card
1. Press the ejection button of the card slot in which the
workshop card is located.
• The subsequent procedure is menu-guided.
2. After the card has been released (mechanical unlocking of the
card), remove the workshop card from the card slot.
3. Use the button or to set the respective activity, such
as "
a".
Menu navigation after removing workshop card
Step / menu display Explanation / meaning
1 The name of the cardholder appears; a progress bar shows that the
DTCO 1381 is transferring data to the workshop card.
2 Enter country at the end of the workday
– Select the country with the button or and
– acknowledge with the button .
Cancel entry of country
– Press the button to cancel the entry of the country.
Select region if required
– Select the region with the button or and
– acknowledge with the button .
3 Continuation of data transfer to workshop card.
4Print day value
– To print the day value, select "ZFT" with the button or , or
select "OP" and
– acknowledge with the button .
5 Continuation of data transfer to workshop card.
6 The workshop card is released, the standard display and the opera-
tional mode (1) appear.
.VTUFSNBOO
 g
zu FOE DPVOUSZ
  áá
&
zu FOE SFHJPO
 á
"/
.VTUFSNBOO
 g
Ijo EBZ

OP
IjoáEBZ
ááááá
ZFT
.VTUFSNBOO
 d
u d LNI
a LN a
1