EDM eco
Operating instructions Display and warning functions
TU00-1404-0311020 © Siemens VDO Trading GmbH 19
Edition 11/2003
English
* Since the vehicle meters were last reset (-> following section).
Resetting vehicle meters
This procedure resets all EDM eco vehicle interface vehicle meters (-> 7, 9) to zero.
This procedure does not affect calibration values for distance travelled and fuel. Calibration values
may only be changed using the unit settings (-> 40 ff.).
Distance travelled calibration value
Fuel calibration value
1 To switch to the vehicle meter display press both keys at the same
time.
2 Press the key until a beep is audible.
Depending on the unit settings you may be asked to enter the system PIN
before deleting information (-> 24).
The reset vehicle meters are not displayed immediately. They are only shown
as zero the next time you display them.
To Next Page
Loading...
