Siemens WG44G2A0ES - Page 45

Troubleshooting en
45
Fault Cause and troubleshooting
The programme does
not start.
2. Clean the pump unit.
→"Cleaning the detergent drawer", Page36
3. Switch the appliance on.
4. If the display appears again after you clean the
pump unit, call customer service.
→"Customer Service", Page53
Note:You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→"Buttons", Page23
The detergent drawer has not been pushed in fully.
▶ Push in the detergent drawer until the symbol goes
out.
The door cannot
beopened.
The temperature is too high.
▶ Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page32
Water level is too high.
▶ Select a suitable programme for draining.
→"Programmes", Page25
Power failure.
▶ Open the door using the emergency release.
→"Emergency release", Page52
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶ Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶ Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
→"Cleaning the drain pump", Page38
The water outlet hose is connected too high.
▶ Install the water outlet hose at a maximum height of
1 metre.
Pump cover is not correctly assembled.
▶ Correctly assemble the pump cover.
Detergent dosage is too high.
▶ Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).