Siemens WG44G2A0ES - Page 51

Troubleshooting en
51
Fault Cause and troubleshooting
Insufficient cleaning. 2. Drain the dispenser.
→"Cleaning the detergent drawer", Page36
3. Clean the dispenser.
4. Refill the dispenser.
→"Filling the dispensers", Page33
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
1. Check whether the detergent used is suitable.
→"Detergents and care products", Page30
2. Drain the dispenser.
→"Cleaning the detergent drawer", Page36
3. Clean the dispenser.
4. Refill the dispenser.
→"Filling the dispensers", Page33
Water is leaking out at
the water inlet hose.
Water inlet hose is not correctly/securely connected.
1. Connect the water supply hose correctly.
→"Connecting the water inlet hose", Page14
2. Tighten the screw connection.
Water is leaking out at
the water outlet hose.
The water outlet hose is damaged.
▶ Replace the damaged water outlet hose.
Water outlet hose is not connected correctly.
▶ Connect the water outlet hose correctly.
→"Water outlet connection types", Page14
Odours have formed
in the appliance.
Humidity and detergent residue may promote the
formation of bacteria.
▶
→"Cleaning the drum", Page36
▶ If you are not using the appliance, leave the door
and detergent drawer open so that residual water
can evaporate.