Siemens WK12D321EE - Page 15

14
Special programmes
retirar pelusas/fios (Fluff Clean)
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol 7 (Fluff removal
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The 7 (Fluff removal
cycle) symbol goes out after the programme starts.
To run the retirar pelusas/fios (Fluff Clean) programme, proceed as
follows:
 Make sure that the drum is completely empty and close the door.
 Set the programme selector to retirar pelusas/fios (Fluff Clean).
 Press the inicio pausa (Start/Pause) button.
You can also run the retirar pelusas/fios (Fluff Clean) programme at any
time without prompting from the appliance.
'+centrigug.0 (Rinse + Spin):
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page15.
++centrifug. 0 (Empty + Spin):
Drain the rinsing water following a programme with $ (Rinse stop)
→ page15.
 Turn the programme selector to ++centrifug.0 (Empty + Spin).
 Set the spin speed to $ (Rinse stop).
 Press the inicio pausa (Start/Pause) button.
or
Drain and spin at the desired spin speed:
 Turn the programme selector to ++centrifug.0 (Empty + Spin).
 Press the 0 (Spin) button repeatedly until the desired spin speed is
set.
 Press the inicio pausa (Start/Pause) button.