Siemens WK14D320EU - Page 12

12
Special programmes
Fluff Clean ?
This programme is executed to clean the drying circuit of any fluff
deposits. The time at which the programme needs to be run is determined
automatically by the washer-dryer and indicated by the
(Fluff Clean) l
symbol on the display panel. The
l (Fluff Clean) symbol remains lit until
the programme has been successfully completed.
To run the Fluff Clean
l programme, proceed as follows:
 Make sure that the drum is completely empty and close the door.
 Set the programme selector to Fluff Clean
?.
 Press the
! (Start/Pause) button.
At the end of the programme, the Fluff Clean
? symbol goes out.
You can also run the Fluff Clean
? programme at any time without
prompting from the appliance.
' + B Rinse + Spin:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page13.
t + B Empty + Spin:
Drain the rinsing water following a programme with $ (Rinse stop)
→ page13.
 Turn the programme selector to
t + B Empty + Spin.
 Set the spin speed to $ (Rinse stop).
 Press the
! (Start/Pause) button.
or
Drain and spin at the desired spin speed:
 Turn the programme selector to
t+ B Empty + Spin.
 Press the B (Spin) button repeatedly until the desired spin speed is
set.
 Press the
! (Start/Pause) button.
i