Troubleshooting en
47
Fault Cause and troubleshooting
Damp stains have
formed on the fabrics
after the end of the
smartFinish pro-
gramme.
Water droplets from the drum or from the door have
moistened the fabrics. The drops come from either
condensed steam or the residual moisture from the
previous wash programme.
▶ Iron the fabrics or hang them up to dry.
Fabric softener re-
mains in the detergent
drawer.
The use of fabric softener is not supported for the se-
lected programme.
▶ Before washing, check whether the use of fabric
softener is supported for the selected programme.
→"Programmes", Page23
Water is leaking from
below the door.
Dirt on the door or seal causes leaks.
▶ Clean the door and the seal.
To Next Page
Loading...
