37
Filter blocked in water inlet hose
First, release water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except Spin/Drain).
3.
Select inicio/pausa+carga Ü (Start/Pause). Leave
programme for approx. 40 seconds.
4.
Press the # button. Appliance is switched off. Pull out the
mains plug!
5.
Clean the filter:
Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:
Remove hose from the rear of the appliance.
Take out filter with pliers and clean.
6.
Connect the hose and check for leaks.
To Next Page
Loading...
