EasyManua.ls Logo

Siemens WM14Y890GB/30 - Page 44

Siemens WM14Y890GB/30
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
7.
Insert service flap (1), engage (2) and close (3).
²
To prevent unused detergent from flowing into the outlet during
the next wash cycle: Pour approx. 1 litre of water into
dispenser À Á and start the Drain programme.
Drainage hose on the siphon blocked
1.
Switch off the appliance. Pull out the mains plug!
Note: Residual water may run out!
2.
Loosen hose clip, carefully remove drainage hose.
3.
Clean drainage hose and siphon spigot.
4.
Re-attach drainage hose and secure connection point with
hose clip.
Filter blocked in water inlet hose
First, release water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except Spin/Drain).
3.
Select Start/Reload Ü. Leave programme for approx. 40
seconds.
4.
Press the # button. Appliance is switched off. Pull out the
mains plug!
5.
Clean the filter:
Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:

Related product manuals