Siemens WU14UT7XES - Page 51

Troubleshooting en
51
Fault Cause and troubleshooting
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow →Page48.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
flashes. The automatic voltage control system detects an un-
authorised voltage under-usage.
▶
No remedial action possible.
Note:If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
flashes. Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page40
Water level is too high.
▶
Start the programme.
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press inicio/pausa+carga to start the programme.
flashes. Door is not closed.
1. Close the door.
2. Press inicio/pausa+carga to start the programme.
All other error codes. Malfunction
▶
Call the after-sales service.
→"Customer Service", Page60
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker is faulty.