Witheachwashcycle.
Compartment
For progr ammes with pre-wash on ly.
(Follow the !)User Manual
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a programme
Turn o n the water tap and press the . T he machine w ill start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the deter gent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break .
They will a lso dry better.Unload the appliance, starting fro m the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Ref er to the dishwashe r loadin g inst ructions.
Close the door,press the Programme Button until the selected programme lights up.
( See the section entitled Oper ation instruction )“”
When the work ing cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the a ppliance is switched
off during a w ash cycle.
Open t he door c ar ef ul l y.
Hot steam may esc ape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-s elect th e washing cycle and operate the dishwasher
according to the origin al Power-on state.
Switch on the appliance Press the On/Off button to switch on the appliance, Open the door.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the deterg ent
m ay have already been rele ased and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.
P ress the Start/Pause button, press the program button for more than three seconds,the
machine will be in standby state, then you can change the program to the desired cycle setting
1.Press the Start/Pause Butt on to stop the washing.
2.Open the door a little .
3.After the spray arms stop w orking, you c an open the door
completely.
4.Add forgotten dishes.
5.Close the door.
6.Press the St a rt/Pau s e Button, the dishwasher will run
after 10 seconds.
To Next Page
Loading...