EasyManua.ls Logo

Sierra Wireless AirPrime MC7710 User Manual

Sierra Wireless AirPrime MC7710
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
AirPrime MC Series Dev Kit
Quick Start Guide
2130705
Rev 2

Other manuals for Sierra Wireless AirPrime MC7710

Question and Answer IconNeed help?

Do you have a question about the Sierra Wireless AirPrime MC7710 and is the answer not in the manual?

Sierra Wireless AirPrime MC7710 Specifications

General IconGeneral
ManufacturerSierra Wireless
ModelAirPrime MC7710
Data Rate (LTE)100 Mbps downlink, 50 Mbps uplink
Module TypeEmbedded module
TechnologyLTE, HSPA+, GSM, GPRS, EDGE
Frequency BandsGSM/GPRS/EDGE 850, 900, 1800, 1900 MHz
InterfacesUSB 2.0, UART, GPIO
Operating Voltage3.3V
InterfaceUSB
Network StandardsLTE, HSPA+, UMTS, EDGE, GPRS, GSM
Operating Temperature-30°C to +75°C

Summary

Safety and Legal Information

Important Notice on Data Transmission

Discusses data transmission reliability and potential damages from delays or losses.

Safety and Hazard Precautions

Outlines precautions regarding explosive atmospheres and aircraft use.

Limitation of Liability Statement

States disclaimer of liability for damages arising from product use or inability to use.

Company and Revision Details

Information on patents, trademarks, copyright, contact, and revision history.

Introduction

Required Development Kit Equipment

Lists essential items needed to start using the Dev Kit for development.

Setup and Installation Guide

Hardware Setup Overview

Details the physical steps for setting up the Dev Kit hardware components.

SIM Card Installation

Step-by-step guide on how to insert the SIM card into the Dev Kit.

Mini Card Installation

Step-by-step guide on how to insert the Mini Card into the Dev Kit.

Antenna Connection

Instructions for connecting the supplied antennas to the Dev Kit.

Power and USB Cable Connection

Guide on connecting the power supply and USB cable to the Dev Kit.

Mini Card Removal and Replacement

Procedure for safely removing or replacing the Mini Card in the Dev Kit.

Host Extender Connection

Instructions for connecting the Dev Kit to a host device via a host extender.

Mini Card Configuration

Explains how to use switches and jumpers for Mini Card configuration.

Software Installation and Drivers

Steps for installing drivers, Watcher, and network software for the Mini Card.

Schematic Diagram

Bill of Materials

Related product manuals