Need help?Do you have a question about the Sigenergy SigenStor-5S-5 and is the answer not in the manual?
Shows the physical appearance and dimensions of the SigenStor unit.
Specifies the required environmental conditions for safe and effective installation.
Details safe and recommended positions for equipment installation.
Outlines the specifications for the surface used for mounting the equipment.
Step-by-step instructions for installing the unit on the floor.
Detailed guide for mounting the inverter and battery pack on a wall.
Overview of various cable routing schemes and types for connections.
Instructions for properly connecting the protective ground wire.
Steps for connecting the AC output cable to the distribution panel.
Details on connecting the RS485 communication cable for sensors.
Information on connecting the RJ45 cable for network communication.
Instructions for connecting the DC input cable from the PV string.
Guide for installing the Sigen CommMod for 4G communication.
Steps for installing the WLAN antenna for wireless communication.
List of essential checks to perform after installation.
Procedures for installing decorative covers on the unit.
Steps to turn on the equipment and check its status.
Explanation of indicator lights and their meaning for system status.
Guide to downloading the app and creating a new system.
General| Nominal Voltage | 51.2 V |
|---|---|
| Nominal Capacity | 100 Ah |
| Usable Capacity | 5.12 kWh |
| Max. Continuous Charging Current | 50 A |
| Operating Temperature | -10°C to 50°C |
| Scalability | Up to 16 units in parallel |
| Protection Level | IP65 |
| Depth of Discharge | 90% |
| Warranty | 10 years |
| Operating Voltage Range | 44.8 - 57.6 V |
| Cycle Life | 6000 cycles |
| Communication | CAN, RS485 |
| Cell Type | LiFePO4 |
To Next Page