8
• The scope ickers, ashes or “snows”…
The scope may icker or ash when used in a bright environment; to correct this, place the cap over the objective lens
and enter a dark environment. The scope will restore itself to a natural functioning state in several minutes or hours,
depending on how long the scope had been exposed to the light. The scope may icker for the rst several seconds of
use, even when in a dark environment, before the scope corrects itself and functions properly. The scope may “snow”
for several minutes after being exposed to a bright light source (daylight, a car’s headlights, re, ect.) even if being
operated in complete darkness.
• The image is not focused…
Adjust the focus of the eyepiece and the objective (see Use and Testing). Check that the lenses are not foggy or dusty;
if they are, carefully clean the external surfaces of lenses with a soft cotton fabric. Replace the batter if the total battery
charge is less than 2.2 V. When the unit is brought into a warm environment from a cold one, condensation may ap-
pear on the internal lenses’ you must wait two hours before using the unit.
• Visibility decreases or disappears…
Bright light sources, such as headlights, may cause visibility to decrease or disappear and the image to icker. Turn the
power o and turn the scope away from the light source; visibility will restore itself in several minutes.
SIGHTMARK LIMITED LIFETIME WARRANTY
Please vist www.sightmark.com for warranty information.
To Previous Page
Loading...