Instruction, use and maintenance manual Pag. 24/39
BMR 20-20H-30 Planetary Mixer
13. Work load and operating instructions
13.1. Operating instructions
The bowl must be positioned on the machine, leaning the bowl
presence block that is on the back part on the bowl lifting arch IN
LOW POSITION.
Complete positioning by matching up the holes on the bowl
resting plates with the centring pins. Lock the bowl with the
handles.
ATTENTION: DO NOT ASSEMBLE THE TOOL BEFORE
HAVING RAISED THE BOWL TO THE WORKING POSITION,
leaving it inside the bowl while the ingredients are added.
RAISE THE BOWL using the lifting lever and, if you have not
already done so, completely rotate the protection grid and insert
the selected tool on the tool carrier shaft. Once inserted, rotate it
clockwise, bringing the drive pin into the work position as shown
in the figure (1). Lower and insert the tool locking ring.
At this point, you can start the work cycle.
In order to work, the machine needs the bowl to be assembled and the bowl
protection grid to be closed, otherwise the safety systems prevent it from operating.
DO NOT REMOVE OR TAMPER WITH THE PROTECTIONS AND ELECTRICAL OR
MECHANICAL SAFETY DEVICES FITTED ON THE MACHINE.
To Next Page
Loading...
