By clicking on a data field you can customize the function and color of the data field.
AUTO PAUSE
If the Auto Pause is activated, the ROX 12.1 EVO automatically goes into pause during a workout as soon
as a speed below 2.2km / h is detected. When a higher speed is detected again, the training is
automatically continued. Tip: Press Stop for longer pauses!
WHEEL CIRCUMFERENCE
The setting of the wheel circumference is mainly relevant for the use of an external speed sensor. How to
connect this is described in the chapter CONNECTING EXTERNAL SENSORS. To determine the correct
wheel circumference, you can either use the following table as a guide, or measure the wheel
circumference. To do this, mark the starting point on the wheel and on the ground. Roll the wheel exactly
one revolution and mark the end point on the floor. Then measure the distance between the start and end
points. This distance gives the correct wheel circumference (in mm). To set the wheel circumference in the
ROX 12.1 EVO, you can choose from one of the following values, alternatively you can also set a manual
value.
To do this, select the “Manual wheel circumference” item and enter your circumference via the numeric
keypad. Press the “check mark” to save the value.
ROUTING OPTIONS
To Next Page
Loading...
