Sigma TAURO 40 - Troubleshooting; Machine Lock-up and Necessary Solutions

Instructions, use and maintenance manual Pag. 37/48
TAURO 35-35PLUS-40-40PLUS
15. Troubleshooting
15.1. Machine lock-up and necessary solutions
Operating anomalies Possible causes Repairs Performed by
Turning the master switch
into position 1, the indicator
light does not come on.
Plug not inserted properly,
or its wires are detached
Check the connection
Personnel
authorised by the
employer and/or
qualified personnel
in possession of the
technical knowledge
of the work.
Pressing the START button,
the machine does not start.
1) The protection grid is
open.
2) Safety micro switches
anomalies.
1) Rotate it and reposition it
in closed position.
2) Replace the micro
switch.
Personnel
authorised by the
employer and/or
qualified personnel
in possession of the
technical knowledge
of the work.
The spiral does not rotate
smoothly.
1) Loose chain or belt.
2) Worn belt.
1) Tension the chain or belt.
2) Replace the belt.
Personnel
authorised by the
employer and/or
qualified personnel
in possession of the
technical knowledge
of the work.
The bowl does not rotate
smoothly.
1) Loose chain.
2) Worn chain.
1) Tension the chain.
2) Replace the chain.
Personnel
authorised by the
employer and/or
qualified personnel
in possession of the
technical knowledge
of the work.