SIGNAL BOOSTER 470410

To Next Page

CELL PHONE SIGNAL BOOSTER DRIVE 4G-X RV

______

Step 1: Mount Outside

Antenna

Determine where you want to have the outside antenna on

your RV. Mount outside antenna to a pole or ladder so that the

entire outside antenna is above the roof line of the RV and

clear of other metal obstructions.

NOTE: Keep in mind to stay below the max height limit allowed by law, which

varies from state to state (generally 14’ in western states and 13’6” in

eastern states).

NOTE: This must be in a location within reach of the booster with the

20’ coax cable (installed in Step 4).

good outside

antenna location

Need help?

Do you have a question about the SIGNAL BOOSTER 470410 and is the answer not in the manual?

Summary

Mount Outside Antenna

Mounting Location and Obstructions

Position antenna above RV roof line, clear of metal obstructions for optimal signal.

Height Limit Compliance

Ensure antenna height adheres to state-specific legal maximums (e.g., 14' western, 13'6" eastern).

Drill Hole

Drilling Procedure

Drill a 1-inch hole towards the top of the RV, avoiding the roof surface itself.

Safety Precautions

Warning to avoid drilling into power, pipes, or other internal RV components.

Connect Cable To Outside Antenna

Cable Routing and Connection

Connect RG-6 cable to antenna, route through cable entry cover into drilled hole.

Booster Location

Booster Mounting

Detach bracket, fasten to surface, then snap booster back into place.

Recommended Placement

Place booster in a cabinet near power, ensuring 20' cable reach.

Connect Outside Antenna Cable To Booster

Antenna Cable Connection

Connect SMA end of cable to booster's 'Outside Antenna' port, hand tighten only.

Mount Cable Entry Cover

Cable Entry Sealing

Secure cover with cable through gasket, use mounts/ties; consider RTV sealant.

Connect Inside Antenna Cable To Booster

Inside Antenna Connection

Connect 13' RG-58 cable to booster's 'Inside Antenna' port.

Optimal Placement

Position inside antenna 4-10 feet from cellular device for best signal.

Power Up The Booster

Power Connection

Connect power cable to booster, then plug into a 110V wall outlet.

Alternative Power Option

Note of an included fused 12V hardwire power supply option.