Need help?Do you have a question about the SignaMax 065 Series and is the answer not in the manual?
General| Category | Media Converter |
|---|---|
| Data Rate | 10/100Mbps |
| Power Supply | 5VDC |
| Series | 065 |
| Fiber Type | Multi-mode or Single-mode |
| Wavelength | 1310nm |
| Distance | 2km (Multimode), 20km (Singlemode) |
| Operating Temperature | 0°C to 50°C |
| Humidity | 5% to 95% non-condensing |
Provides a general introduction to the Signamax RS-232/422/485 to 100BaseFX Media Converter and its capabilities.
Lists the key features and capabilities of the Signamax RS-232/422/485 to 100BaseFX Media Converter.
Details the technical specifications of the media converter, including standards, ports, data rates, and distances.
Presents optical data specifications for different fiber types and connectors, including TX power and sensitivity.
Lists all items included in the Signamax RS-232/422/485 to 100BaseFX converter package.
Details the pin configurations for the DB9 female connector for RS-232, RS-422/485 4-wire, and RS-485 2-wire interfaces.
Explains how to set the converter's DIP switches to establish serial port connection for console or data communication modes.
Guides on connecting the converter to DTE devices, detailing the Console Mode configuration steps.
Outlines the procedure for setting up the converter in Data Communication Mode for DTE connections.
Provides instructions for connecting the converter to DCE devices using the Data Communication Mode.
Step-by-step guide on how to properly connect SC or ST fiber optic cables to the converter's 100BaseFX port.
Explains the meaning of the Power (PWR), Link/Activity (LNK/ACT), and Activity (ACT) LEDs for monitoring status.
Details how to access and configure the media converter using a terminal emulator via the RS-232 console port.
Presents the main menu screen offering access to system information and various configuration settings.
Describes how to view system details and configure IP address, subnet mask, and gateway settings.
Explains how to enable DHCP to automatically obtain an IP address for the converter.
Details settings for RS-232, RS-422, and RS-485 modes, including data rates and parity, before data transfer.
Covers advanced serial port settings like baud rate, parity, word length, stop bits, and flow control.
Provides a screen displaying real-time system status and activity information.
Instructions for upgrading the converter's firmware using a TFTP server and specifying the firmware file.
Command to revert the converter's settings back to the original factory defaults.
Command to restart the converter, applying any saved configuration changes.
Guide for remotely configuring the converter using Telnet, including IP address setup.
Explains the syntax and usage of various CLI commands for managing the converter, such as backup, set, and reset.
Illustrates the pin-to-pin wiring for RS-232 connections between DTE and DCE devices.
Details the specific pin assignments for RS-422 and RS-485 4-wire serial communication.
Details the specific pin assignments for RS-485 2-wire serial communication.
Visual examples demonstrating typical DTE-to-DTE and DTE-to-DCE network configurations using the converter.
Provides official contact details, addresses, phone numbers, and website for Signamax and its global support centers.
To Next Page