Selection of installation equipment
- Cut out the work surface according to the sizes shown in the
drawing.
- For the purpose of installation and use, a minimum of 50mm space
shall be preserved around the hole.
- Be sure the thickness of the work surface is at least 30mm. Please
select heat-resistant work surface material to avoid larger
deformation caused by the heat radiation from the hotplate. As
shown below:
INSTALLATION
-20
Put a towel or cloth on the work surface. Place the hob face down on the
protected surface.
Apply the strip seal, supplied with the hob, which is for sealing it onto the
work surf .eca
Do not use silicone. Apply the seal to the edge of the bottom of the hob,
leaving about 3mm from the edge of the glass. Apply the seal all around the
circumference.
Cut any excess and bring the two ends of the seal together so they match.
To Next Page
Loading...
