A(mm) B(mm) C(mm) D E
760 50 mini 20 mini Air intake Air exit 5mm
Before installing the hob
- The work surface is square and level, and no structural members
interfere with space requirements.
- The work surface is made of a heat-resistant material.
- If the hob is installed above an oven, the oven has a built-in cooling
fan.
- The installation will comply with all clearance requirements and
applicable standards and regulations.
- A suitable isolating switch providing full disconnection from the
mains power supply is incorporated in the permanent wiring,
mounted and positioned to comply with the local wir
ing rules and
regulations.
- The isolating switch must be of an approved type and provide a 3
mm air gap contact separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for this variation of the
requirements).
-22
To Next Page
Loading...
