The power supply cable must not touch any hot parts and must be
positioned so that its temperature will not exceed 75℃ at any point.
Check with an electrician whether the domestic wiring
system is suitable without alterations. Any alterations must
only be made by a qualified electrician.
- If the cable is damaged or needs replacing, this should be done by
an after-sales technician using the proper tools, so as to avoid any
accidents.
- If the appliance is being connected directly to the mains supply, an
omnipolar circuit-breaker must be installed with a minimum gap of
3mm between the contacts.
- The installer must ensure that the correct electrical connection has
been made and that it complies with safety regulations.
- The cable must not be bent or compressed.
- The cable must be checked regularly and only replaced by a
proper qualified person.
EN-25
L1 L2 N1 N2 E
Brown
Black
Blue
Grey
Green-Yellow
L1 L2 N1 N2 E
Brown
Black
Blue
Grey
Green-Yellow
220 240V
～
380 415V
～
L N E
Brown
Blue
Green-Yellow
220-240V
～
220-240V
～
220-240V
～
To Next Page
Loading...
