Need help?Do you have a question about the Siklu EtherHaul 8000 Series and is the answer not in the manual?
General| Ingress Protection | IP67 |
|---|---|
| Modulation | QPSK, 16QAM, 32QAM, 64QAM, 128QAM, 256QAM |
| Latency | <40 µsec |
| Antenna Gain | 43dBi |
| Antenna Type | Integrated |
| Polarization | Dual, Vertical / Horizontal |
| Interface | SFP |
Overview of key features and capabilities of the EtherHaul product line.
Details the main functional blocks and components of the EtherHaul system.
Guidelines for selecting and preparing radio sites, including physical and environmental requirements.
Step-by-step instructions for installing the radio with 0.5ft/1ft and 2ft antennas.
Covers connecting cables, power supply options (DC and PoE), and grounding procedures.
Detailed steps for performing coarse and fine alignment of the antennas.
How to launch a web browser and connect to the radio's web interface for management.
Instructions for establishing an SSH connection to the radio using a CLI client like PuTTY.
Explains general commands like Apply, Save Configuration, Rollback, and Reboot.
How to copy configuration settings from the local unit to the remote unit.
Configuration of basic radio parameters like channel bandwidth, Tx/Rx frequency, and Tx power.
Configuration of advanced radio features like ATPC and modulation profiles.
Maintenance tasks for the radio, including RF loopback and mute settings.
Monitoring radio performance using statistics counters and viewing RF performance.
Configuration of Ethernet ports, including port type, enablement, and auto-negotiation.
Configuration of MTU and Alias settings for Ethernet ports.
Maintenance tasks for Ethernet ports, including line loopback and timeouts.
Configuration of basic system parameters like model name, date, and time.
Configuration of advanced system settings like system uptime and loopback permissions.
System maintenance tasks including file transfer, SW upgrade, licensing, scripts, and config management.
Configuration for masking alarms and events, and setting thresholds for alarms.
Configuration of IP addresses, default gateway, static routes, SNMP managers, and NTP.
Configuration of management access lists, SNMP agent, SNMPv3 users, and syslog servers.
Management of system users, including local authentication and password strength policies.
Configuration and monitoring of the Link Layer Discovery Protocol (LLDP).
Overview of the system's Provider Bridge (IEEE 802.1ad) and its cross-like connection.
Configuration of bridge ports, including port type (Customer/Provider) and VLAN settings.
Configuration of egress VLAN settings using bridge rules (Add or Translate).
CLI commands for managing bridge ports and bridge rules.
Configuration for managing users via TACACS+ or RADIUS servers, including AAA.
Setting up SNMPv3 users, including authentication and privacy protocols.
How to display and monitor active CLI sessions on the system.
A step-by-step guide to diagnosing and resolving problems with the radio link.
Explanation of the meaning and status of various system LED indicators.
Details on system alarms, their probable causes, and corrective actions.
Using Ethernet and RF loopbacks for fault isolation and performance testing.
Monitoring RF statistics, including summaries, error counts, and modulation profiles.
Monitoring bandwidth usage per port, showing in/out octets, rates, and utilization.
Monitoring Ethernet port statistics, including packet counts and error rates.
CLI commands for viewing and clearing RF, bandwidth, and Ethernet statistics.
To Next Page
