Silencer 7919P - Valet and Override Switch Operation; Using the Valet Switch

4
Removable Valet/Override Switch Operation
Override Operation: (Security System is Armed)
1. Enter the vehicle (6908A, 6918A, 7919P and 7921P security systems
will begin sounding at this point) and place the override switch into the
switch housing. Make sure that the switch button is in the “off” position
2. Place the ignition key into the ignition switch and turn the ignition
switch to the “on” position.
3. Within 5 seconds of turning the ignition key “on”, place the valet switch
to the “on” position.
4. The horn/siren will stop sounding. (6908A, 6918A, 7919P and 7921P
Only)
5. The LED indicator will be solid red.
The security system is overridden and is now in the valet mode!
Note 1: If the valet switch is already in the “on” position when you turn “on” the ignition key, the override
function will be bypassed. Turn “off” the ignition key, place the valet switch in the “off” position and try again.
Note 2: If you fail to place the valet switch to the “on” position within 5 seconds of turning “on” the
ignition key, the override function will be locked out. Place the valet switch in the “off” position, turn “off”
the ignition key and try again.
Valet Operation: (The security system is already disarmed)
1. Place the valet switch into the switch holder making sure that the switch button is in the “off” position.
2. Turn the ignition key to the “on” position
3. Within 5 seconds of turning the ignition key “on”, place the valet switch to the “on” position.
4. The LED will be on solid indicating that the security system is in the valet mode.
Note 1: If the valet switch is already in the “on” position when you turn “on” the ignition key, the valet
function will be bypassed. Turn “off” the ignition key, set the valet switch to the “off” position and try again.
Note 2: If you fail to push “in” the valet switch within 5 seconds of turning “on” the ignition key, the valet
function will be locked out. Turn “off” the ignition key, set the switch to the “off” position and try again.
Caution: Be careful and not to bend the override switch pins when put it into
the housing. Also note the the override switch can only go into the housing
one way.
See diagram to note shape of housing.
"Off"
Position
"On"
Position
To provide a higher level of protection, all Silencer security systems are supplied with the patented
removable valet switch system. The removable valet switch is used to override the security system in the
event that the transmitters are lost or fail to operate and to put the security system in non-operational
mode (valet) for vehicle servicing etc.