Osiris-Jaegar – Installer Guide
Safety Information.
Before installing the equipment, please read this guide carefully.
To prevent electrical shock hazards, disconnect the power from electrical sources before working on the
equipment.
Make all connections with the power turned off. Do not make or remove connections when the power is
turned on.
Before using the product ensure that all cables are correctly connected and that the power cables are not
damaged.
Ensure that the product is secured correctly in all situations. Do not place the equipment on to a trolley, table
desk or other platform that is not stable; to avoid the product from falling over.
Ensure that the power supply to be used is correct for the equipment and the correct input voltage for your
region. If unsure, contact your local power supply company. If the power supply or cables are broken, do not
use them. Contact a qualified electrical services technician or your retailer.
Do not use any equipment that appears damaged or incomplete. If you detect damage, contact your dealer
immediately.
Do not allow connectors to be exposed to long-term water immersion.
Do not allow electrical contacts or leads to be exposed to dust, humidity or moisture. Do not allow electrical
contacts or cable-ends to become wet.
The equipment must be firmly secured using appropriate fixings and fastening as appropriate to the
mounting surface that the unit is being affixed to.
Disclaimer
The manufacturer reserves the right to change specifications and procedures integral to the operation,
control and programming of this product at any time and without prior notice.
Installation.
IMPORTANT: Always use sprung washers and
Nyloc® nuts in order to significantly reduce the
possibility of bolts working loose due to vibration
during operation.
Cable entry path must be watertight to avoid ingress
and build-up of water around the connector.
IMPORTANT: Ensure that the lanyard is connected to
the appropriate lug on the mount adaptor when the
camera mounting is complete. Also, double check all
bolts for correct positioning and appropriate tightness.
Silent Sentinel SilSen DN145003 - 1.2b (Fork)
2
To Next Page
Loading...