Silent Sentinel Osiris - Page 4

Osiris-Jaegar – Installer Guide
The main menu
The main menu provides access to all camera configuration features and contains numerous sub-menus
within it:
Silent Sentinel Oculus
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
>Lens options
>Goto preset
>Run tour
Pan/Tilt Control Normal
>Setup (protected)
Using SSUTILITY Off
CAM2 control Timed
Minimum zoom Off
Reboot camera
Exit menu
Send a Preset 2 command to access the Main Menu –
(Preset 2 is the Factory default value which may be adjusted- see
CONFIGURATION menu)
Lens options is only displayed if a lens with enhanced functions
is installed.
Lens options – provides access to enhanced lens functions where this is supported – (Ref. Appendix 5).
Goto preset – shows a list of the presets. Selecting a preset will apply it. Presets that are defined are
marked with an ‘@’ symbol.
Run tour – shows a list of the tours and mimic tours. Selecting a tour will run it.
Pan/Tilt Control – sets the type of response to manual (Joystick) speed inputs for Pan and Tilt motion.
Normal sets a linear response. Linear 255 allows for a high reolution of 255 speed values (non-standard).
Quad and Quad255 apply a quadratic response to allow finer control of slower speeds.
Setup (protected) – accesses the setup and configuration menu (see below for details). The setup
password will be requested before access to the menu is allowed. The default setting for the password is
AAAAAA (6 characters).
Usung SSUtility – Allows specific functionality if the SSUtility computer programme is being used.
CAM2 control – Sets the control method for the secondary camera and lens (e.g. Thermal imager) if fitted.
Timed: uses Preset-9 (Ref. Appendix 1) to direct controls to the secondary camera. If control is not toggled
back to the Primary camera by the operator the function will timed-out.
Sticky: will cause the change of control to the Secondary camera to remain until the operator changes it – no
time-out.
FollowV: will cause the control to be applied to whichever camera image is being displayed on the principle,
video output No.1.
Minimum Zoom – Sets zoom limit for Front Mounted Magnifier lenses – Applies to specific models only.
Reboot camera – resets the PT unit as though it has just been powered on. This is required by some
configuration changes and is also useful if you suspect there may be a camera error as the POST is run.
Silent Sentinel SilSen DN145003 - 1.2b (Fork)
4