SMZC 500 C2
■ 8 │ GB│IE│NI│CY
Operation
Chopping
1) Place the bowl 9 on the non-slip ring q.
2) Place the blade holder 7 with the blade 8 onto the guide axis 0.
3) Prepare the food:
CAUTION – PROPERTY DAMAGE!
► Particularly hard foods should be cut into small pieces (approx. 2 cm)
before processing. Otherwise, the motor unit could block.
Use a pulsing processing method when working with hard foods. To do
this, press the relevant speed button 1/2 several times.
– Chop solid food into pieces approx. 2 cm in size.
– Removes stems and stalks from herbs.
– Remove the shell from nuts, e.g. walnuts.
– Remove bones, skin and sinew from meat.
4) Add the food to the bowl 9. Use the following table as an orientation aid
here:
Food Fill level Processing time Speed
Garlic 50 g
pulse approx.
5 x 1 sec.
Level II
Onions 150 g
pulse approx.
5 x 1 sec.
Level I
Carrots 200 g 2 x 5 sec. Level I
Almonds 200 g
coarse: 1 x 5 sec.
medium: 1 x 10 sec.
fine: 3 x 10 sec.
Level II
Meat (cubed
2 x 2 cm)
250 g 6 x 5 sec. Level II
Ice cubes 100 g
pulse
coarse 10 x 1 sec.
fine 20 x 1 sec.
Level II
The times and quantities listed in this table are guide values and can vary
depending on the composition of the processed food!
5) Place the lid 5 onto the bowl 9 so that the sealing ring 6 rests on the edge
of the bowl 9 and the blade holder 7 protrudes through the opening of the
lid 5.
One of the two catches e that are located on the inner ring of the lid 5
should point forwards, towards you.
To Next Page
Loading...
