GB
│
IE
│
17 ■
SHBR 560 B1
Ƈ Allow the dirt filter 0, the waste water tank 2 and the lid of the waste water
tank
9 to dry completely (see fig. 27).
Ƈ Once the parts are fully dry, replace the dirt filter
0 back in the lid of the waste
water tank 9 (see fig. 28).
Fig. 27 Fig. 28
Ƈ Place the lid of the waste water tank
9 back onto the waste water tank 2
(see fig. 29).
Ƈ Fit the waste water tank
2 back onto the appliance by inserting the bottom
of the waste water tank 2 first. Then push the waste water tank 2 into the
appliance until the waste water tank 2 audibly clicks into place (see fig. 30).
Fig. 29 Fig. 30
To Next Page
Loading...
