Silvercrest HG00783B - Preparing for use; Inserting;replacing the batteries

11 GB/IE
Note: Only use the screws and dowels supplied for the assembly of
the device.
Mount the receiver (see Fig. D)
Mount the transmitter (see Fig. E)
Preparing for use
Inserting / replacing the batteries
Insert the batteries to provide power to the device before prepar-
ing it for use.
CAUTION! Use the indicated battery types only. Failure to ob-
serve this advice may result in damage to the product.
Receiver (see Fig. B):
Remove the battery compartment cover
6
from the back of the
device.
Remove the used batteries, if present.
Insert 3 batteries (1.5 V , type AA).
Note: Ensure correct polarity. This is indicated in the battery
compartment
8
.
Close the battery compartment
8
.
Transmitter:
Remove the holder
12
by pressing the lock
11
from the back of
the transmitter and remove the rubber cover
15
(see fig. C1).