SBLL 56 A1
GB
│
IE │ 35 ■
Button Function
The button
controls the lighting
on the light surface
as follows in a
circle, starting with the light surface
switched off (the first two lighting
programmes vary depending on the
position of the speaker):
► Press once: The light surface
shows a multicoloured colour
change in time with the music
using a flashing colour strip in the
middle of the speaker (horizontal
position) or below (vertical posi-
tion). The light surface
starts in
this programme when the speaker
is switched on.
► Press twice: The light surface
shows a multicoloured colour
change in time with the music
using a flashing colour strip along
the whole breadth of the speaker
(horizontal position) or below
(vertical position).
► Press three times: Large-scale colour
changes run over the entire light
surface
in a repeating pattern.
► Press four times: Fast, diagonal
colour changes run over the entire
light surface
in a repeating
pattern.
► Press five times: Single-colour
stripes run quickly over the light
surface
and the colour chang-
es roughly every 2 seconds.
► Press again: The light surface
switches off and the cycle starts
from the beginning the next time
you press the button.
To Next Page
Loading...
