Silvercrest SBZBK 850 A1 - Dust container and HEPA filter; Motor filter; Ordering replacement accessories

13GB
m
ATTENTION! Do not use any tools to clean
the filters. Otherwise the filters could be
damaged.
m
ATTENTION! Never use the product
without the HEPA filter and motor filter
[].
Otherwise the product could be damaged
and the suction power could be decreased.
 Switch off the product and disconnect the
power plug
[9] from the socket-outlet.
 Press the hose release
[] and pull the
hose
[1] out of the intake [] (Fig. M).
 Do not use any corrosive or abrasive
cleaning agents.
 Remove coarse dirt by hand.
 Clean the product with a damp cloth. For
stubborn dirt, use a damp cloth and a mild
detergent and clean the product again.
Dust container and HEPA filter
(Fig. N)
 Remove the dust container
[4]
(see “Emptying the dust container”).
 Pull up the lid lock (top)
[3]. Open the top
lid.
 Pull out both cylinders (grey and blue).
 Separate the cylinders from each other.
To do this, turn one of the cylinders
counterclockwise.
 Use a damp cloth to clean the dust
container
[4] and the two cylinders. You can
also rinse the dust container and cylinders
under running water.
 Pull the filter frame out of the lid.
 Remove the foam inlay [].
 To remove dust, tap the filter frame.
 If necessary, rinse the filter frame and the
foam inlay
[] under running water. Let the
parts dry completely at a location without
direct sunlight.
Motor filter
(Fig. O)
NOTE: Clean the motor filter [] if it is dirty.
With normal use, it is recommended to clean
the motor filter every 6 months.
 The motor filter
[] is located behind the air
outlet grille
[]. Slide the grille lock [] to the
left. At the same time pull out the air outlet
grille.
 Carefully press down the lock on top of the
filter frame. Pull out the filter frame.
 Rinse the motor filter
[] under running warm
water.
 Let the motor filter
[] dry completely at a
location without direct sunlight.
 Insert the motor filter
[] and the air outlet
grille
[] back into the product. Both parts
must audibly lock in place.
 Ordering replacement
accessories
 Replacements for the following accessories
can be ordered online:
–
[] Motor filter
–
[] Foam inlay
 Item number: 391635_2201
Website: www.optimex-shop.com