Silvercrest SDM 1500 D2 - Assembling the Appliance; Disposal of Packaging Materials

■ 26
│
GB
│
MT SDM 1500 D2
Disposal of packaging materials
The packaging protects the appliance from damage during carriage.
The packaging materials have been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging to the material cycle conserves raw materials and reduc-
es the amount of waste that is generated. Dispose of packaging materials that
are no longer needed in accordance with applicable local regulations.
NOTE
► If possible, keep the appliance's original packaging during the warranty
period so that the appliance can be packed properly for return shipment
in the event of a warranty claim.
Dispose of the packaging in an environmentally friendly manner.
Note the labelling on the packaging and separate the packaging material
components for disposal if necessary. The packaging material is labelled with
abbreviations (a) and numbers (b) with the following meanings:
1–7: Plastics,
20–22: Paper and cardboard,
80–98: Composites.
Assembling the appliance
♦ Push the main unit 3 onto the connection nozzle 4 on the steam foot 5 and
press the main unit 3 down until the round catch clicks into place.
♦ Select the appropriate pad 6/o for the surface being cleaned:
– the blue pad o for carpets and sensitive surfaces, such as parquet flooring,
– the white pad 6 for more robust surfaces, such as tiled floors.
♦ Attach a pad 6 from below onto the steam foot 5.
NOTE
► If you intend to clean carpeting with the steam mop, fit the blue pad o and
place the steam foot 5 on the carpet ringp. Ensure that the carpet ring
unlocking aid a is in line with the connection nozzle 4. Push the steam
foot 5 onto the carpet ring p so that it clicks audibly into place. This will
allow the blue padoto glide over the carpet.
► To remove the carpet ring p, press your foot onto the carpet ring release
aid a and pull the steam foot 5 carefully off the carpet ring p.