GB
│
IE
│
NI
│
9 ■
SDR 1100 B2
Operating the appliance
WARNING! RISK OF INJURY!
To ensure fault-free operation and a long service life for the
appliance, pay heed to the following instructions:
► Do not press the steam lever
until the green control lamp
5
lights up.
If you press too early, it may cause an accumulation of hot water in the
steam nozzle
6
which will drip or spray from the nozzle. There is a risk
of scalding.
► Before switching off, allow all of the steam to escape from the appliance.
Press the steam lever
until no more steam comes out of the steam
nozzle
6
.
Filling/refilling with water
RISK OF ELECTRIC SHOCK
► Always disconnect the plug from the mains power socket before you add
water to the water tank
3
!
CAUTION – PROPERTY DAMAGE!
► Do not put any additives or cleaning agents in the water tank
3
!
♦ Open the safety valve
8
.
NOTE
► The safety valve
8
can only be opened if all the steam has been let out of
the water tank
3
.
► Ensure that you fill the appliance’s water tank
3
with around 250 ml of water.
♦ Fill the water tank
3
with water through the filler opening
7
.
♦ To do this, use the supplied measuring cup
16
and the funnel
17
for assistance
(see figure). Fill the measuring cup
16
with water up to the marking line
(approx. 250 ml).
♦ Reclose the safety valve
8
.
To Next Page
Loading...
