Silvercrest SEMM 1470 A1 - Inserting the Espresso Sieves in the Sieve Holder

GB
│
IE
│
NI
│
11 ■SEMM 1470 A1
Inserting the espresso sieves in the sieve holder
1) Place the large / or the small espresso sieve in the sieve holder ,:
– Make sure that the small indentation on the large / or small espresso
sieve lies on the indentation on the sieve holder , when you put it in.
– Then turn the large / or small espresso sieve a little so that it cannot
fall out.
NOTE
► Do not remove the used espresso sieve / until it has cooled down!
► To remove the espresso sieve / from the sieve holder , turn the
espresso sieve / until the indentation on the espresso sieve / is
over the indentation on the sieve holder ,. You can now remove the
espresso sieve / .