■ 20
│
GB
│
IE SEMM 1470 A2
7) Use the “Steam quantity” dial 5 to adjust how much steam comes out of
the milk nozzle 0 together with the milk. This changes the consistency of
the milk foam:
Turn the “Steam quantity” dial 5 anticlockwise to decrease the amount
of steam. The milk foam becomes coarser.
Turn the “Steam quantity” dial 5 clockwise to increase the amount of
steam. The milk foam becomes creamier. Make sure you do not turn the
“Steam quantity” dial 5 further than the “
” marking. Otherwise, you will
be in cleaning mode (see section “Cleaning and care”).
NOTE
► You can also correct the amount of steam during preparation by turning the
"Steam quantity" dial 5.
8) Switch the appliance on using the on/off switch i and wait until all control
lamps light up permanently. The appliance has now heated up.
9) Press the “Small” latte button w
if you want to prepare a small latte
macchiato. The control lamp for the “Small” latte button w
lights up.
Press the “Large” latte button 3
if you want to prepare a large latte
macchiato. The control lamp for the “Large” latte button 3
lights up.
10) The appliance starts the brewing process; the corresponding control lamp
flashes during the preparation.
11) Wait until the espresso has stopped flowing out of the espresso outlet q,
the milk has stopped flowing out of the milk nozzle 0 and all control lamps
light up. You can now remove your latte macchiato.
NOTE
► You can stop the preparation at any time by pressing any button.
NOTE
► If you want to add a little extra frothed milk to your drink: Press the "Large"
cappuccino button 2
2x in a row. The control lamp for the "Small"
cappuccino button e
and the control lamp for the "Large" cappuccino
button 2
light up and frothed milk comes out of the milk nozzle 0.
Stop the milk output by pressing any button. The milk will stop coming out
automatically after 70 seconds.
To Next Page
Loading...
